Chevy Astro and GMC Safari Forum banner
Cancel

Bolt in C Notch?

2596 Views 7 Replies 5 Participants Last post by  AstroWill, 
2
Hello, New to forum. Have a 2000 Safari Rwd and was going to go with Belltech spindles and Belltech lowering leafs. Going with chassis tech Bolt in C notch. Will bolting in in be OK?Anyone done this? Thanks
Reply
Save
Like
1 - 2 of 8 Posts
MI_Ghost
The Belltech 3" drop springs should not need the c-notch. The axle will remain below the springs.
Only with the 6" flip kit which places the axle above the springs would the c-notch be required.
Reply
Save
Like
MI_Ghost
Correct. The c-notch provides clearance for the axle tubes not the bump stops. Shorter bump stops are used when lowering the rear.
Reply
Save
Like
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevy Astro and GMC Safari Forum
A forum community dedicated to Chevy Astro and GMC Safari owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Engines Uncategorized Electrical Exterior Projects/Builds
Top