Chevy Astro and GMC Safari Forum banner

new wheels & tires

3744 Views 17 Replies 10 Participants Last post by  blackpowder
Hi guys, I'm new here and just bought a 2003 Astro. I'm looking at tires and wheels for it. The van will have Journeys 3-5 kit on it.
I'm wondering what offset and backspace I need, and should I stay with 16" or go larger? Wanting to put as Tall of a tire as I can and not rub off-road.The van will mostly be on pavement, but when it is off-road it will be on gnarly Hawaiian back roads.
For 30+ years I have always used BFG A/Ts on my trucks, but got a bad set on the last round so I sent them back and got Nitto Ridge grapplers.
I can worry about tires after I figure what size wheels to go with.
Any suggestions?

Thanks
1 - 2 of 18 Posts
Hi guys, I'm new here and just bought a 2003 Astro. I'm looking at tires and wheels for it. The van will have Journeys 3-5 kit on it.
I'm wondering what offset and backspace I need, and should I stay with 16" or go larger? Wanting to put as Tall of a tire as I can and not rub off-road.The van will mostly be on pavement, but when it is off-road it will be on gnarly Hawaiian back roads.
For 30+ years I have always used BFG A/Ts on my trucks, but got a bad set on the last round so I sent them back and got Nitto Ridge grapplers.
I can worry about tires after I figure what size wheels to go with.
Any suggestions?

Thanks
New here also. Just put these wheels and tires on yesterday. Also has a Journey 3-5" lift.
Wheel Tire Car Automotive parking light Vehicle
See less See more
  • Like
Reactions: 1
Good looking van Blackpowder.....
Do you have a picture looking down the side, are the tires inside the fenders?
What are the specs on tires and wheels?
US Wheel series 54 Rallye, 16x7 4" BS, Rallye centers and rings, Toyo open country AT3 245/75x16. Probably going to raise it another inch.
Tire Wheel Car Vehicle Land vehicle
See less See more
1 - 2 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top