Chevy Astro and GMC Safari Forum banner

Front driveshaft seal questions

684 views 3 replies 3 participants last post by  AstroWill 
#1 ·
Hey everyone, I've been searching on the internet for some pics but no real luck so far so I thought I'd just ask... When doing the front driveshaft seal on the transfer case (1995), do you have to remove these torx bolts or will the yoke just slide out? I can't tell if the yoke is bolted in and these torx bolts are absolutely kicking my butt so far.
 
#4 ·
So you are replacing the output shaft seal on the transfer case? Shouldn't need anything special, except maybe a torque wrench to put the nut back on. Are you using a repair manual? It's covered in the FSM.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top