HELP! TPS and MAP sensor connection mistake?!

[observer]

I bought this 1989 van from someone, and today after checking the wiring/connectors on the van against a service manual, I suspect the previous owner swapped the TPS and MAP sensor connectors by mistake (because they look the same except for colors). If there was really an error, I am a bit surprised the van can and have been driven like that for quite a long time!

Could someone please please check for me how yours are connected, and tell me which is the correct connector (shown in attached picture) for TPS?

On the black connector (this was connected to MAP):
A terminal: black wire
B: dark blue
C: grey

On the green connector (this was connected to TPS):
A terminal: black wire with red strip
B: green wire with black strip
C: grey

[AstroWill]

That is crazy, must have been in 'limp home' mode for a while.

On the black connector (this was connected to MAP):
A terminal: black wire
B: dark blue
C: grey

Yep, that belongs on the TPS

On the green connector (this was connected to TPS):
A terminal: black wire with red strip
B: green wire with black strip
C: grey

And that one belongs on the MAP sensor.

[dcsleeper]

It runs, right? < sez the seller >