Quick read out

[catbones]

Hey, I took a quick shot of a reading while drying and idling. I felt like my RPMs were little night, anyone see an issue anywhere?

[Drummernaut]

Are you using a stock tire size?

[Jasen]

at 60 mph I'm usually sit'n about 1650 pushin 1700 rpm. Your idle rpm is rriight in there with mine as well as engine temp and MAP

[Sailing_Faith]

What program is this? I recall there was a thread about this lately, but I did not recall seeing a display?

Thanks,

[Jasen]

I recently posted about putting an ultra gauge in. Looks like the OP is running a smart phone app.

[Jasen]

catbones read my thread https://www.astrosafari.com/viewtopic.php?f=9&t=30713
I bet you can get that 16.1 mpg up a bit. With my 1500 lb load I was hitin 15.8 mpg in my rush hr commute.

[TaxiVan]

With stock 15-inch tires, 3.73 gears will likely push around 2500 rpm at 70 mph. Sounds about right to me.

[catbones]

Are you using a stock tire size?

No idea really, figuring out is on my lower part of list. I'm 98% sure they are, stock. Why?

[catbones]

catbones read my thread https://www.astrosafari.com/viewtopic.php?f=9&t=30713
I bet you can get that 16.1 mpg up a bit. With my 1500 lb load I was hitin 15.8 mpg in my rush hr commute.

Hahaa... Beat me to it. I was testing this for a few as I like to know what's up. I don't have an overhead console so I was working on building my own and integrating a low cost android phone with the app, hooked into my built and wired. Won't even know its a phone if it works out. I might take the approach of not using a phone if it becomes expensive but use a LCD display hooked to raspberry pi.

Out loud thinking.

[Jasen]

That was $70. it's 2 1/8" x 3 7/16" x 1/2" supports more parameters then then ECM puts out, it offers me 48-49 readings.

You might be interested in the open source MPGuino.

http://ecomodder.com/wiki/index.php/MPGuino

http://ecomodder.com/forum/opengauge-mpguino-fe-computer.html