PO757 Code selinoid 'B" malfuncion

[Rinny]

So I am running the beaches, lots of soft sand, have never had to air down with lo range and posi Front and rear difs. Running a NP236 with an alternate shift pattern for 4lo, SES light comes on today and it seems like the trans is slipping. Clear the code and it is fine, Put it in 4 lo and the light comes back on. Take It out of 4lo and switch to 2H, switch To he standard shift pattern and it seems like the trans is slipping again, Clear the code and all is well in 2H. Does anyone have input on if it is the solenoid, or faulty infernal wiring for he solenoid?

[Rinny]

Going to have to drop the pan either way so I will do the filter, and why not test for continuity and replace the solenoids, rite?

[albrow100]

I’d replace the solenoid and the internal harness while your in there
Both are cheap enough

[Rinny]

I’d replace the solenoid and the internal harness while your in there
Both are cheap enough

Thanks. did no realize the harness is a plug and play, and that could be the problem seeing the scanner keeps bouncing back between reading a code and no codes.

[Rinny]

I am also going o have the tranny flushed rite b4 I drop the pan and change the filter. Running Valvoline max life synthetic.